Just run part of macro

[QSC999]

Hi,
how can i run a macro line by line or define a startingpoint from where to run till an defined point, where execution comes to an halt. I want to do this to test code.

Greetings!

[Gintaras]

Cannot run part of code without modifying the code.
I usually disable parts of code to be excluded when testing.
It's easy to disable/enable parts of code: select the lines and right-click the selection bar.

In this macro, out 1, 2, 5, 6 are disabled.
Macro Macro2760

Code:

Copy      Help

;out 1
;out 2
out 3
out 4
;out 5
;out 6

[QSC999]

Ah o.k. one can not do this. To "out-comment" code is actually what i already do...

greetings!

[ldarrambide]

maybe insert a goto instruction where you want the code to end execution.
Then you move it lines forward when needed.





The goto section is either a stop instruction (say use ret 0) or some other code to process...
Just my 2 cents, hope it can help.

something like this mayben untested though

Macro Macro11

Code:

Copy      Help

goto mygoto
out 1
out 2

;mygoto
out 3
out 4
goto mygoto1
out 5
out 6


;mygoto1
ret 0