12-05-2013, 08:05 AM
I am running a macro that visits web pages, checking for their content.
After visiting about 500 pages, the computer starts clogging, I get a wait error message, and the macro stops.
- If I run the macro again, it may visit just under 10 pages more.
- If I restart the computer, it may visit about 100 pages.
- if I shut down the computer, and start afresh, I get back to the 500.
The macro is set up for Internet Explorer,
however, Firefox works much faster in my computer.
I did disable everything I could in Quick Macros.
Any suggestions to improve performance,
other than using multiple computers at a time?
Thank you.
After visiting about 500 pages, the computer starts clogging, I get a wait error message, and the macro stops.
- If I run the macro again, it may visit just under 10 pages more.
- If I restart the computer, it may visit about 100 pages.
- if I shut down the computer, and start afresh, I get back to the 500.
The macro is set up for Internet Explorer,
however, Firefox works much faster in my computer.
I did disable everything I could in Quick Macros.
Any suggestions to improve performance,
other than using multiple computers at a time?
Thank you.