03-25-2014, 12:48 AM
I am not sure if this is related to my hardware/OS setup.
If I go to the icon editor through the button with the three small squares icon: red, green blue and then:
step 1: select a line thickness
step 2: after step 1, select another line thickness the previous selected line thickness stays selected.
step 3: after step 2, the third selected line thickness stays selected AND the one in step 2. The one selected in step 1 get's de-selected.
In short: line thickness button doesn't toggle the previous selected button off. (always 2 at the same time stay selected).
If I go to the icon editor through the button with the three small squares icon: red, green blue and then:
step 1: select a line thickness
step 2: after step 1, select another line thickness the previous selected line thickness stays selected.
step 3: after step 2, the third selected line thickness stays selected AND the one in step 2. The one selected in step 1 get's de-selected.
In short: line thickness button doesn't toggle the previous selected button off. (always 2 at the same time stay selected).
